EP-133 MIDI channels: which pad sends what

The EP-133 K.O. II sends and receives MIDI over USB and its TRS jacks, but which pad sends which note, and on which channel, depends on two settings. This page explains both, with what we measured on a unit running OS 2.5.1. If you record the EP-133 into a DAW and every drum comes out as the same note, this is why (and here are two fixes).

In short

Two settings decide it: the system MIDI code (110 or 127) and each pad's channel in Sound Edit. A pad with its own channel is an instrument on that channel under both codes; a pad on "default" only sends and plays under 110.

The two settings

1. The system MIDI setting (SHIFT+ERASE, type the code on the pads, ENTER). The manual's table gives these codes; we measured 110 and 127 on OS 2.5.1:

OFFsystem code127✕default pads send nothing✕default pads play nothing✕CC 12 / 13 do nothing✓pads with a channel: instrumentsALLsystem code110✓default pads send notes 36–83, ch 1✓play from notes on any channel✓CC 12 / 13 move the FX✕pattern playback: one note, ch 1
What a pad left on MIDI "default" does under each code. 111 to 126 presumably pick another channel; we haven't measured them.

2. The channel of each pad, the MIDI setting in Sound Edit: a channel 1 to 16 or "default". It is stored per pad, per project.

What a pad does with its own channel

Measured on OS 2.5.1 with pads set to their own channels:

Everything above was measured on one EP-133 (OS 2.5.1, November 2026). We haven't tested an EP-40; it is the same family, but we can't promise it behaves the same.

Recording the EP-133 into a DAW (Ableton Drum Rack and others)

  1. Give each drum pad its own MIDI channel in Sound Edit.
  2. In the DAW, use one MIDI track per channel, or one track set to "All Channels" with a MIDI effect that maps channels to Drum Rack notes.
  3. Record. Live hits send the root note on the pad's channel too, so recording and playback match.

If you only need a few drums, one channel per pad and one track each is the simplest.

Playing the EP-133 from a keyboard or DAW

A drum kit: code 110

  • Send the manual's pad notes (36 to 83) on any channel: each note triggers one pad at its own pitch, like a drum map, with nothing to set per pad.

A bass or chords: a channel

  • Set one pad to its own channel (either code) and send notes on that channel: the pad follows the pitch.

Doing it in one click

Padwork can give one group's 12 pads channels 1 to 12 and the other groups one channel each (13 to 16), and change the mapping when you switch groups on the device, so every pad has its own channel without going through Sound Edit 48 times. It uses the same per-pad setting described above, nothing hidden.

Last checked: 2 November 2026, OS 2.5.1